Troubleshooting - ARTHUR MARTIN AWF8240SXM Notice D'utilisation

22
Frost precautions
If the appliance is installed in an area
where the temperature can be less than 0°
C, remove the remaining water from the
inlet hose and the drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Put the two ends of the inlet hose in a
container and let the water flow out of
the hose.

TROUBLESHOOTING

WARNING! Refer to Safety
chapters.
Introduction
The appliance does not start or it stops
during operation.
First try to find a solution to the problem
(refer to the table). If the problem persists,
contact the Authorised Service Center
With some problems, the acoustic
signals operate and the display shows
an alarm code:
• - The appliance does not fill with
water properly.
Possible failures
Problem
The programme does
not start.
4. Empty the drain pump. Refer to the
5. When the drain pump is empty, install
•
•
•
•
Possible solution
• Make sure that the mains plug is connected to the mains
socket.
• Make sure that the appliance door is closed.
• Make sure that there is not a damaged fuse in the fuse box.
• Make sure that the Start/Pause has been pressed.
• If the delay start is set, cancel the setting or wait for the end of
countdown.
• Deactivate the Child Lock function if it is on.
• Make sure that the mains plug is connected to the mains
socket.
• Make sure that the mains plug is connected to the mains
socket.
emergency drain procedure.
the inlet hose again.
WARNING! Make sure that the
temperature is higher than 0 °C
before you use the appliance
again.
The manufacturer is not
responsible for damages
caused by low temperatures.
- The appliance does not drain
the water.
- The appliance door is open or
not closed correctly. Please check the
door!
- The mains supply is unstable.
Wait until the mains supply is stable.
- No communication between
electronic elements of the appliance.
Switch off and switch on again.
WARNING! Deactivate the
appliance before you do the
checks.