Safety Instructions - ARTHUR MARTIN AWF8240SXM Notice D'utilisation

General Safety
Do not change the specification of this appliance.
•
Do not exceed the maximum load of 8 kg (refer to the
•
"Programme chart" chapter).
The operating water pressure at the water entry point from
•
the outlet connection must be between 0.5 bar (0.05 MPa)
and 8 bar (0.8 MPa).
The ventilation opening in the base must not be covered
•
by a carpet, mat, or any floor covering.
The appliance must be connected to the water mains using
•
the new supplied hose sets, or other new hose sets
supplied by the Authorised Service Centre.
Old hose sets must not be reused.
•
If the mains power supply cable is damaged, it must be
•
replaced by the manufacturer, its Authorised Service
Centre or similarly qualified persons to avoid an electrical
hazard.
Before any maintenance operation, deactivate the
•
appliance and disconnect the mains plug from the socket.
Do not use high pressure water sprays and/or steam to
•
clean the appliance.
Clean the appliance with a moist cloth. Use only neutral
•
detergents. Do not use abrasive products, abrasive
cleaning pads, solvents or metal objects.

SAFETY INSTRUCTIONS

Installation
The installation must comply
with relevant national
regulations.
• Remove all the packaging and the
transit bolts including rubber bush with
plastic spacer.
• Keep the transit bolts in a safe place. If
the appliance is to be moved in the
future they must be reattached to lock
the drum to prevent an internal
damage.
• Always take care when moving the
appliance as it is heavy. Always use
safety gloves and enclosed footwear.
• Do not install or use a damaged
appliance.
• Follow the installation instructions
supplied with the appliance.
• Do not install or use the appliance
where the temperature can be less
than 0°C or where it is exposed to the
weather.
• The floor area on which the appliance
is to be installed must be flat, stable,
heat resistant and clean.
3