ARTHUR MARTIN AWF8240SXM Notice D'utilisation page 16

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

16
Press the Départ/Pause button
again to start the programme
immediately.
Interrupting a programme and
changing the options
You can change only some options before
the programme carries them out.
1. Press the Départ/Pause
interrupt the running programme.
The related indicator flashes.
2. Change the options.
3. Press the Départ/Pause
again.
The programme continues.
Cancelling a running
programme
1. Turn the programme knob to position
to cancel the programme and to
deactivate the appliance.
2. Turn the programme knob again to
activate the appliance. Now, you can
set a new washing programme.
Before starting the new
programme the appliance could
drain the water. in this case,
make sure that the detergent is
still in the detergent
compartment, if not fill the
detergent again.
Opening the door when the
delay start operates
While the delay start operates, the
appliance door is locked and the display
shows the indicator
1. Press Départ/Pause
appliance.
2. Wait until the door lock indicator
goes off.
3. Open the door.
4. Close the door.
5. Press Départ/Pause
The delay start continues to operate.
button to
button
.
to pause the
again.
Opening the door when the
programme operates
While the programme operates, the
appliance door is locked and the indicator
appears.
CAUTION! If the temperature
and level of the water in the
drum are too high, you cannot
open the door.
1. Turn the programme knob to position
to deactivate the appliance.
2. Wait some minutes until the indicator
goes off and then open carefully
the appliance door.
3. Close the appliance door.
4. Set the programme again.
At the end of the programme
• The appliance stops automatically.
• The acoustic signal operates (if it is
activated).
• In the display three flashing zeros
come on.
• The indicator of the Départ/Pause
goes off.
• The door lock indicator
• You can open the door.
• Remove the laundry from the
appliance. Make sure that the drum is
empty.
• Close the water tap.
• Turn the programme knob to the
position
to deactivate the appliance.
• Keep the door ajar, to prevent the
mildew and odours.
The washing programme is completed,
but there is water in the drum:
• The drum turns regularly to prevent the
creases in the laundry.
• The door lock indicator
door stays locked.
• You must drain the water to open the
door.
To drain the water:
1. Turn the programme knob to spinning
or draining programme.
goes off.
is on. The

Publicité

Chapitres

Table des Matières
loading

Table des Matières