Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Problem
The appliance does not
fill with water properly.
The appliance does not
fill with water and drain
immediately.
The appliance does not
drain the water.
The spin phase does not
operate or the washing
cycle lasts longer than
usually.
There is water on the
floor.
You cannot open the ap‐
pliance door.
The appliance makes an
unusual noise.
The cycle is shorter than
the time displayed.
Possible solution
•
Make sure that the water tap is open.
•
Make sure that the pressure of the water supply is not too low.
For this information, contact your local water authority.
•
Make sure that the water tap is not clogged.
•
Make sure that the filter of the inlet hose & the filter of the
valve are not clogged. Refer to "Care & Cleaning"
•
Make sure that the drain hose has no kinks or bends.
•
Make sure that the connection of the drain hose is correct.
•
Make sure that the drain hose is in the correct position. The
hose may be too low.
•
Make sure that the sink spigot is not clogged.
•
Make sure that the drain hose has no kinks or bends.
•
Make sure that the drain filter is not clogged. Clean the filter, if
necessary. Refer to "Care and cleaning".
•
Make sure that the connection of the drain hose is correct.
•
Set the drain programme if you set a programme without drain
phase.
•
Set the drain programme if you set an option which ends with
water in the tub.
•
Set the spin option.
•
Set the drain option if you set an option which ends with water
in the drum.
•
Make sure that the drain filter is not clogged. Clean the filter, if
necessary. Refer to "Care and cleaning".
•
Adjust manually the items in the tub and start the spin phase
again. This problem may be caused by balance problems.
•
Make sure that the couplings of the water hoses are tight and
there is not water leakages.
•
Make sure that the drain hose have no damages.
•
Make sure you use the correct detergent and the correct
quantity of it.
•
Make sure that the washing programme is finished.
•
Set the drain or the spin programme if there is water in the
drum.
•
Make sure the levelling of the appliance is correct. Refer to
"Installation".
•
Make sure that the packaging and/or the transit bolts are re‐
moved. Refer to "Installation".
•
Add more laundry in the drum. The load may be too small.
•
The appliance calculates a new time according to the laundry
load. See the "Auto sense function" at daily use chapter.
23
Publicité
Chapitres
Table des Matières
