11: Electrical Connection; Disposal And Recycling - Scheppach dp13 Traduction Du Manuel D'origine

m Attention! Unplug the machine!
The appliance must unconditionally be secured
against falling or turning down during transport.
The appliance can be lifted on the left and right grin-
ding wheel / belt sander cover. Power cable, flexible
lamp shaft etc. should not be used for transport
purpose.
11. Electrical connection
The installed electric motor is completely wired ready
tor operation.
The customer's connection to the power supply sys-
tem, and any extension cables that may be used,
must conform with local regulations.
Defective electrical connection cables
Electrical connection cables offen suffer insulation
darnage.
Possible causes are:
• Punch points when connection cables are run
through window or door gaps.
• Kinks resulting from incorrect attachment or laying
of the connection cable.
• Cuts resulting from running over the connecting
cable.
• Insulation darnage resulting from forcefully pulling
out of the wall socket.
• Cracks through aging of insulation.
Such defective electrical connection cables must
not be used as the insulation darnage makes
them extremely hazardous.
Check electrical connection cables regularly for dar-
nage. Make sure the cable is disconnected from the
mains when checking.
Electrical connection cables must comply with the
regulations applicable in your country .
Single-phase motor
• The mains voltage must coincide with the voltage
specified on the motor.s rating plate.
• Dimension cables up to a length of 25 m must have
a cross-section of 1.5 mm
least 2.5 mmª.
• The connection to the mains must be protected with
a 16 A slowacting fuse.
Important remark:
The motor is automatical/y switched off in the event
of an overload. The motor can be switched on again
after a cooling down period that can vary.
Three-phase motor
• The mains voltage must be between 380 and 420
V / 50 Hz.
• The connection to the mains and the connection
cable must have five leads (3 P + N + PE).
• Extension cables must have a cross-section of at
least 1.5 mm .
2
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
. and beyond 25 m at
2
Warning:
The drill press must not be operated in the open air.
The machine must have an earth Gable to protect the
operator from etectrical shocks.

Disposal and recycling

12.
The equipment is supplied in packaging to prevent
it from being damaged in transit. The raw materials
in this packaging can be reused or recycled. The
equipment and its accessories are made of various
types of material, such as metal and plastic. Never
place defective equipment in your household refuse.
The equipment should be taken to a suitable collec-
tion center for proper disposal. If you do not know
the whereabouts of such a collection point, you
should ask in your local council offices.
GB
25 / 44