SATA jet 4800 K spray mix Mode D'emploi page 157

Warning!
Risk of injuries from components coming loose or leaking
material.
The air micrometer may shoot out of the spray gun in an uncontrolled
manner.
→ When screwing in the locking screw, ensure the air micrometer is
correctly aligned.
→ Check the locking screw for tight fit.
■ Screw in a new seal retainer [15-2] using the original SATA Combi-Tool
[15-1] (size 4).
■ Grease a new air piston rod [14-4] using SATA high-performance
grease (Art. No. 48173) and insert. Check correct installation direction.
■ Insert a new air piston washer [14-1] and head [14-3].
■ Grease a new air micrometer [14-2] using SATA high-performance
grease (Art. No. 48173) and insert. Check correct installation direction.
■ Firmly screw in the locking screw [13-1] using the original SATA Com-
bi-Tool [13-2].
■ Carry out the working steps „Mount a new trigger guard" (see chap-
ter 10.4).
■ Carry out the working steps „Fit new nozzle head" (see chapter 10.2).
■ Carry out the working steps „Fit a new pre-nozzle, hard metal ball
tip and paint needle" and „Mount a new material nozzle" (see chap-
ter 10.1).
10.7. Replacing spindles of round/flat fan control
Dismantle spindle
■ Unscrew the countersunk screw [16-1] using the SATA Combi-Tool.
■ Remove the control knob [16-2].
■ Unscrew the spindle [16-3] using the SATA universal spanner (size 12).
Mount new spindle
■ Position a new spindle [16-3] and screw in using the SATA universal
spanner (size 12).
■ Position the control knob [16-2].
■ Secure the countersunk screw [16-1] with Loctite 242 and hand-tighten
it using the SATA Combi-Tool.
Operating instructions SATAjet 4800 K spray mix
EN
157