En.4.2 Assembly Of The Suction Hose, Hand Pipes; And Floor Tool; En.5 Operation Of The Tennant 3400; En.6 Switching Off The Tennant 3400 - Tennant 3400 Mode D'emploi

Tennant 3400
EN.4.2 Assembly of the suction hose,
hand pipes and floor tool
Disconnect the plug from the main power
supply!
Holding the rubber cuff of the suction hose coupling,
insert it into the tank socket and rotate it clockwise.
Assemble the two straight pipes and elbow by simply
pushing them together. Now fit the floor tool to the
lower end of the straight pipe and connect the end of
the suction hose to the elbow section.
The length of the wand may be adjusted to
suit the operator. Simply remove the elbow
section, turn it arround and reinsert it into the
straight section.

EN.5 Operation of the Tennant 3400

Ensure that the paper filter bag and filter cartridge are
in the tank of the machine and correctly positioned.
Always ensure that filters are clean and serviceable
and that the suction hose, wand and floor tool are not
blocked. Connect the plug to the main power supply
and switch the machine on by pressing the on/off
switch.

EN.6 Switching off the Tennant 3400

Switch the machine off by pressing the on/off switch.
Disconnect the plug from the main power supply wall
socket. Do not pull on the cable as it may be
damaged. Always wind up the cable and hang it on the
handle/cable hanger on the top cover of the machine.

EN.7 Maintenance Advice

EN.7.1 Normal Maintenance

Always disconnect the plug from the main power
supply before commencing any cleaning or
maintenance of the machine. Always refer to the
manufacturers technical data and instructions when
replacing any parts.
Regular maintenance has three stages:
Daily inspection:
Visually inspect machine for any damaged parts,
S
damaged cables or electrical connections and
S
check that the paper filter bag is neither full nor
S
damaged.
Monthly Maintenance:
Check the brush strips on the floor tool – if worn out
S
these should be changed.
Check the cartridge filter -- should it be cleaned or
S
replaced?
8
Home Find... Go To..
Annual Check Up:
Clean the cable and inspect for damaged insulation.
S
Clean and lubricate the wheels and castors.
S
Check all machine functions.
S

EN.7.2 Replacement of Filters

Please use only original Tennant filters and
take note of the instructions on the filter or filter
pack!
Spare filters can be purchased from your Tennant
distributor. Please note that only genuine Tennant
filters are guaranteed to give a constant high filter
performance.

EN.7.2.1 Paper Filter Bag

Please take note of the information printed on each
genuine Tennant paper filter bag -- it will assist you
when changing the bag.
Firstly, hold the rubber cuff of the suction pipe
coupling, rotate this anti--clockwise and remove the
coupling from the tank connector.
(10- -05)