Set-Up Position (Instrument Configuration) - Chauvin Arnoux CA 6470 Mode D'emploi

The MR function (second function of MEM key) is used to read the stored measurement
results.
nd nd nd nd nd
2 2 2 2 2 + + + +
MR MR MR
MR MR
03:06 03:06
FREE OCC
OBJ:TEST OBJ:TEST
OBJ:TEST:1,2,3 OBJ:TEST:1,2,3,4
OBJ:TEST:DISTANCE OBJ:TEST:DISTANCE
Exit from mode

3.3 SET-UP POSITION (INSTRUMENT CONFIGURATION)

This function is used to change the instrument configuration by direct access to the parameters to be
modified.
With the rotary switch set to the SET-UP position :
- All the segments on the display are activated for 1 second and the "PUSH button" message
appears on the display,
- The various parameters are accessible by pressing the corresponding key (see table
below),
- The numbers or symbols which can be modified flash. These are changed using the
and keys,
- All the parameters which have been modified are permanently saved until a new parameter
modification is performed.
Parameter to be modified
Distance unit
Ω Ω Ω Ω
m 2P measurement alarm
Buzzer
Modbus address
Date
Time
Baud
Default configuration
Memory occupation
MEM MEM MEM MEM MEM
Indication of last position stored
Choice of measurement to
be displayed
nd nd nd nd nd
2 2 2 2 2 + + + + MEM MEM MEM MEM MEM
MR MR MR
Key
DISPLAY
nd
DISPLAY
(2 action)
rd
DISPLAY
(3 action)
th
DISPLAY
(4 action)
CONFIG
nd
CONFIG
(2 action)
rd
CONFIG
(3 action)
th
CONFIG
(4 action)
MEM
39
Possible values Default values
m (meter) or ft (feet)
ON / OFF
direction (< or >)
value (1...999Ω)
ON / OFF
1...247
yyyy.mm.dd Current date
hh : mm Current time
9.6k / 19.2k / 38.4k 9.6 k bits
yes / no
xxx on 512 (total 000 on 512
number of locations)
m
OFF
>
2Ω
ON
1
yes