Maintenance; Storage And Cleaning Of Instrument; Metrological Verification; Warranty - After-Sales Service - Chauvin Arnoux CA 6470 Mode D'emploi

5 MAINTENANCE

For maintenance, use only specified spare parts. The manufacturer will not be held responsible
for any accident occurring following a repair which has not been performed either by the
manufacturer's after-sales service or an approved repair agent.

5.1 STORAGE AND CLEANING OF INSTRUMENT :

Storage
If the instrument has not been used for an extended period of time (more than 6 months), before
re-using the instrument, perform several complete charge/discharge cycles (3 to 5 cycles) to recover
the battery's initial capacity .
To perform the discharge cycle (approximate time: 15 hours), set the unit for the "Resistance
measurement" (rotary switch in mΩ position), configure the unit for "MANUAL" mode, (see above,
§4.2.2), and set up a short-circuit across the H and E terminals.
Cleaning
The instrument must be disconnected from any source of electricity.
Use a soft cloth, slightly moistened with soapy water. Rinse using a damp cloth and dry quickly using a
dry cloth or pulsed air. Do not use alcohol, solvents or hydrocarbons.

5.2 METROLOGICAL VERIFICATION

The instrument must be checked periodically as for all measurement and test instruments.
This instrument should be checked at least once annually.
For the checks and calibrations, contact our COFRAC certified metrology laboratories or a
MANUMESURE agency.
Information and contact details on request:
Tel. : 02 31 64 51 43 Fax : 02 31 64 51 09
5.3 WARRANTY – AFTER-SALES SERVICE
Repairs covered/not covered by warranty.
Send your instruments to one of the regional MANUMESURE agencies approved by CHAUVIN
ARNOUX.
Information and contact details on request:
Tel. : 02 31 64 51 43 - Fax : 02 31 64 51 09
Repairs outside metropolitan France.
For all interventions covered/not covered by warranty, return your instrument to your dealer.
52