Yamaha RX-V992 Mode D'emploi page 63

Adjusting delay time
You can adjust the time difference between the beginning of the
sound from the main speakers and the beginning of the effect
sound from the rear or front effect speakers.
The larger the value, the later the effect sound is generated.
This adjustment can be made to all programs individually.
Program
1. DOLBY PRO LOGIC
DOLBY DIGITAL
2. PRO LOGIC ENHANCED
DOLBY DIGITAL ENHANCED
3. MOVIE THEATER
DIGITAL MOVIE THEATER
4. TV SPORTS
5. STADIUM
6. DISCO
7. ROCK CONCERT
8. JAZZ CLUB
9. CHURCH
10. CONCERT HALL
NOTES
• Adding too much delay will cause an unnatural effect with some
sources.
• When the –/+ button is pressed, sound is momentarily
interrupted.
Adjusting output level of the center, right rear and
left rear speakers, and subwoofer
speaker even if the output level is already set in "SPEAKER
BALANCE ADJUSTMENT" on pages 40 to 41.
Control range (ms)
15 to 30
0 to 15
15 to 30
0 to 15
15 to 30
NOTES
1 to 50
•
1 to 50
1 to 50
1 to 50
1 to 50
1 to 50
•
1 to 50
1 to 50
NOTE
The values of the delay time and each speaker level you set the
last time will remain memorized even when the power of this unit is
off.
However, if the power cord is kept disconnected for more than one
week, these values will be automatically changed back to the
original factory settings.
If desired, you can adjust the sound output level of the each
Speakers
Control range (dB)
CENTER
MIN, –20 to +10
RIGHT SURROUND MIN, –20 to +10
LEFT SURROUND MIN, –20 to +10
SUBWOOFER MIN, –20 to 0
Output level of the center speaker cannot be adjusted when the
program STADIUM, DISCO, ROCK CONCERT, JAZZ CLUB,
CHURCH or CONCERT HALL is selected, and the input signal
is analog, PCM audio or encoded with the Dolby Digital (AC-3)
in 2-channels.
Once the output level is adjusted, the level value will be the
same in all the digital sound field programs.
Preset value
0
0
0
0
59