Yamaha RX-V992 Mode D'emploi page 28

CONNECTING TO DIGITAL (OPTICAL AND COAXIAL)
JACKS
If your LD (DVD) player, TV/satellite tuner, etc. are equipped
with coaxial or optical digital audio signal output jacks, they can be
connected to this unit's COAXIAL and/or OPTICAL digital signal
input jacks.
To make a connection between optical digital audio signal
jacks, remove the cover from each jack, and then connect them by
using a commercially available optical fiber cable that conforms to
EIAJ standards. Other cables might not function correctly.
Even if you connect an audio/video unit to the OPTICAL (or
COAXIAL) jack of this unit, you must keep the unit connected with
the same named analog audio signal jacks of this unit, because
digital signal cannot be recorded by a tape deck or VCR
connected to this unit, and digital signal also will not be output
from the AUDIO SIGNAL ROOM 2 OUT jacks. You can switch the
selection of input signals between "digital" and "analog" easily.
(See page 46 for details.)
NOTE: When connecting an audio/video unit to both of the digital
and analog jacks of this unit, make sure to connect to both jacks of
the same name.
NOTE: Be sure to attach the cover when the OPTICAL jack is not
being used, in order to protect the jack from dust.
24
LD (DVD) player
ANALOG OUT
OPTICAL COAXIAL
DIGITAL OUT DIGITAL OUT
TV/Satellite tuner
COAXIAL
DIGITAL OUT
ANALOG OUT
NOTE: All digital audio signal input jacks are applicable to the
sampling frequency of 32 kHz, 44.1 kHz and 48 kHz.
FREQUENCY AUDIO SIGNAL AUDIO SIGNAL
STEP
PHONO DVD/LD
FM AM
50kHz 9kHz
I00kHz I0kHz
1
TV/DBS
CD
AM
IN
ANT
VCR 1
3
GND
OUT
TAPE
PB
TAPE(MD)
4
FM
IN
REC
ANT
OUT
VCR 2
75Ω
UNBAL.
PCM/ DIGITAL IN
OUT
(AC – 3 DIGITAL IN)
DVD/LD TV/DBS
GND
ROOM 2
COAXIAL
OUT
OPTICAL
IN OUT
DVD/LD PAL NTSC
REMOTE
CONTROL
VIDEO S
VIDEO
VIDEO
MONITO