Technical Information - Electrolux GA60KV220 Notice D'utilisation

Problem
The anti-flood device is on.
After the checks are completed, activate
the appliance. The programme continues
from the point of interruption.
If the problem occurs again, contact the
Service.
If other alarm codes appear, contact the
Service.
10.1 If the washing and drying
results are not satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is too
much. Adjust the rinse aid selector to a
lower position.
• The quantity of detergent is too much.
Stains and dry water drops on
glasses and dishes
• The released quantity of rinse aid is not
sufficient. Adjust the rinse aid selector
to a higher position.
• The quality of the detergent can be the
cause.
Dishes are wet
• The programme is without a drying
phase or with a low temperature drying
phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
• The quality of the combi detergent tab-
lets can be the cause. Try a different
brand or activate the rinse aid dispens-
er and use rinse aid together with the
combi detergent tablets.
Refer to 'HINTS AND TIPS' for
other possible causes.

11. TECHNICAL INFORMATION

Dimensions
Electrical connection
Possible solution
Close the water tap and contact the Service.
10.2 How to activate the rinse
aid dispenser
The activation of the rinse aid dispenser
can occur only with the Multitab option
activated.
1. Press the on/off button to activate the
2. Press and hold, at the same time, pro-
3.
4.
5. Press the on/off button to deactivate
6. Adjust the released quantity of rinse
7. Fill the rinse aid dispenser.
Width / Height / Depth (mm)
Refer to the rating plate.
Voltage
appliance. Make sure that the appli-
ance is in setting mode, refer to "Set-
ting and starting a programme".
gramme button
button until the indicators of pro-
gramme buttons
start to flash.
Press programme button
• The indicators of programme but-
tons and
• The indicator of programme button
continues to flash.
• The end indicator is off.
Press programme button
end indicator comes on. The rinse aid
dispenser is activated.
the appliance and to confirm the set-
ting.
aid.
596 / 818 - 898 / 550
ENGLISH 63
and programme
, and
.
go off.
. The
220-240 V