Troubleshooting - Electrolux GA60KV220 Notice D'utilisation

62 www.electrolux.com

10. TROUBLESHOOTING

The appliance does not start or it stops
during operation.
Before you contact the Service, refer to
the information that follows for a solution
to the problem.
Alarm code
• The indicator of the set programme
flashes continuously.
• The end indicator flashes 1 time in-
termittently.
• The indicator of the set programme
flashes continuously.
• The end indicator flashes 2 times in-
termittently.
• The indicator of the set programme
flashes continuously.
• The end indicator flashes 3 times in-
termittently.
WARNING!
Deactivate the appliance before
you do the checks.
Problem
You cannot activate the appli-
ance.
The programme does not start.
The appliance does not fill with
water.
The appliance does not drain the
water.
With some problems, different indica-
tors flash continuously or intermit-
tently at the same time to show an
alarm code.
Problem
The appliance does not fill with water.
The appliance does not drain the water.
The anti-flood device is on.
Possible solution
Make sure that the mains plug is connected
to the mains socket.
Make sure that there is not a damaged fuse in
the fuse box.
Make sure that the appliance door is closed.
If the delay start is set, cancel the setting or
wait for the end of the countdown.
Make sure that the water tap is open.
Make sure that the pressure of the water sup-
ply is not too low. For this information, con-
tact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not
clogged.
Make sure that the inlet hose has no kinks or
bends.
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or
bends.