Options - Electrolux GA60KV220 Notice D'utilisation

2) The appliance senses the degree of soil and the quantity of items in the baskets. It
automatically adjusts the temperature and quantity of the water, the energy consumption
and the programme duration.
3) This programme has a high temperature rinsing phase for better hygiene results. During the
rinsing phase, the temperature stays at 70 °C for at least 10 minutes.
4) With this programme you can wash a load with fresh soil. It gives good washing results in a
short time.
5) With this programme you have the most efficient use of water and energy consumption for
crockery and cutlery with normal soil. (This is the standard programme for test institutes).
6) Use this programme to quickly rinse the dishes. This prevents the remaining food to bond
on the dishes and bad odours to come out from the appliance.
Do not use detergent with this programme.
Information for test institutes
For all the necessary information for test performance. send an email to:
info.test@dishwasher-production.com
Write down the product number (PNC) that is on the rating plate.

5. OPTIONS

Activate the Multitab option before
you set a programme. You cannot
activate the option while a pro-
gramme operates.
5.1 Multitab
Activate this option only when you use the
combi detergent tablets.
This option deactivates the flow of rinse
aid and salt. The salt indicator stays off.
The programme duration can increase.
How to activate the Multitab option
1. Press and hold, at the same time, but-
ton
Multitab indicator comes on.
If you stop to use the combi
detergent tablets, before you start to
use separately detergent, rinse aid
and dishwasher salt, do these steps:
1. Set the water softener to the highest
level.
2. Make sure that the salt container and
the rinse aid dispenser are full.
3. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
4. Adjust the water softener to the water
hardness in your area.
and button until the
5. Adjust the released quantity of rinse
aid.
5.2 Acoustic signals
The acoustic signals operate when the
appliance has a malfunction, when the
adjustment of the level of the water soft-
ener occurs and when the programme is
completed.
By default, the acoustic signals are on,
but it is possible to deactivate them.
How to deactivate the acoustic
signals
1. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode, refer to 'Set-
ting and starting a programme'.
2. Press and hold, at the same time, but-
ton and button
cators of buttons
and start to flash.
3.
Press button
• The indicators of buttons
and go off.
•
The indicator of button
ues to flash.
ENGLISH 55
until the indi-
,
.
contin-