Deleting A Remote Control; Programming Recognition Of New Sensors - Conrad 75 13 64 Notice D'emploi

14.4.1 Deleting a Remote Control

Proceed as follows to delete a remote control from the memory in the alarm control centre:
Step Action
1 Press „PROG" (12).
2 Enter the four digit master code
3 Press button 0
4 Press the button 6, 7, 8, 9 or 0
(depending on the memory position
of the remote control to be deleted).
** Explanation of „zone status LEDs" (1) from step 3 in the table above:
„Zone status LED" (1)
Does not light up
Flashes twice
Flashes once
Flashes once and then twice

14.5 Programming Recognition of New Sensors

You can programme up to ten additional wireless sensors to the alarm system. There are five zones
available for this. Each zone can have two wireless sensors programmed to it. Before you programme in
a new sensor, you should think about which sensor memory position you would like to save it to. We
suggest that you carefully read the following „Sensor Allocation Instructions".
Also take care to read through the individual settings options before you begin with the „Sensor
Allocation Instructions" and the corresponding programming of new sensors:
- section „14.1 Configuration of the acoustic alarm"
- section „14.2 Automatic Muting"
- section „14.3 Alarm zones (bypass zones)"
- section „14.7 Event set off"
Function
You enter the programming
mode.
You enter the programming
mode to delete a remote control
from the memory in the alarm
control centre.
Explanation
No remote control has been programmed to this zone yet.
A remote control has already been programmed to this zone. You could choose this
zone to delete the corresponding remote from the memory.
An (optionally available) wireless switching module has already been programmed to
this zone. You should, thus, not delete this memory position.
A wireless switching module and a remote control have both already been pro-
grammed to this zone. You could choose this zone to delete the corresponding remote
from the memory.
Note
3 x a short beep confirms entry of
the correct code. 1 x long beep
indicates incorrect code entry.
As soon as you enter the
programming mode, the „zone
status LEDs" (1) light up or flash.
** See following table for further
explanation
A voice message confirms the
successful deletion.
79