Conrad 75 13 64 Notice D'emploi page 66

• Number of repetitions: This is the number of times the emergency voice message will be
repeated (possible number 1 to 9).
• You can exit the programming mode at any time by pressing the „PROG" button (12) and
thus interrupt the process.
• if no telephone number is entered the „PROG" LED (9) continues to blink.
• „Do not enter the number of the Police, Fire Brigade etc.!"
• Ensure that all the telephone numbers that you enter are correct. Write down the numbers
that you allocate and inform the people who will be called in the case of an alarm.
To programme the telephone numbers, please proceed as follows:
Step Action
1 Press „PROG" (12).
2 Enter the four digit master code
3 Press button „1".
4 Press the button 1-5.
5 Enter the area code and telephone
number and then press the „ARM"
button (3).
6 Enter the number of redial attempts
by pressing the button 1, 2, 3, 4, 5, 6,
7, 8 or 9
Then press the "ARM" key (3).
7 Enter the number of voice message
repetitions by pressing the button
1, 2, 3, 4, 5, 6, 7, 8 or 9
Then press the "ARM" key (3).
Testing the allocated telephone numbers
Once you have allocated the telephone number(s), you should ensure that they are correctly
programmed. This can by triggering a silent alarm (by entering the duress code), this causes the
entered telephone numbers to be called one after another as programmed.
Don't forget to inform the people who are automatically contacted in an emergency when your alarm is
triggered. These people should know the security codes for your alarm system so that they have control
over the system via telephone in case of an alarm situation.
• Press „ARM" (3). You hear a signal tone (beep).
• Enter the „duress code". The beep stops and the internal alarm dialler begins to dial the telephone
number allocated to memory position 1.
• The participator that has been called picks up and a little later a voice message is played (this may last
up the several seconds, depending on the telephone system)
Function
You enter the programming
mode.
You enter the programming
mode for telephone number
allocation.
You enter the desired telephone
memory, five telephone memories (depending on the button pressed)
are available (button 1, 2, 3, 4, 5). „telephone 1".
The telephone number can be
up to 29 digits long
The redial attempt number is the
number of times a telephone
number is to be redialled after an
initial failed call. Each telephone
number can have a different
number of redial attempts.
The number of repetitions
determines how many times
the message will be repeated
(max. 9).
Note
3 x a short beep confirms entry of
the correct code. 1 x long beep
indicates incorrect code entry.
You hear the command:
"Enter Phone Memory
You hear a command
You hear the command:
"Enter Redial"
You hear the command:
"Enter Repeat"
You hear a command:
"Phone Accepted".
65