Deactivation Of The Burglar Alarm (Panic Alarm); Panic Alarm - Conrad 75 13 64 Notice D'emploi

• Enter your master code and the secondary security code to deactivate the burglar alarm.
• The voice announcement „System inaktiviert, System Notfall" ("system inactivated, system emergen-
cy") is played, a beep is audible and the LED for the referring zone of the excited sensor is flashing.
Please observe the following notes:
The burglar alarm is now deactivated; it now runs in "emergency mode". It is now
necessary to deactivate the sensor that has been activated to confirm the emergen-
cy (e.g. walk through the detection zone of the excited motion sensor or shut the
window of the excited door/window sensor). The zone LED stops flashing, the beep
will fade.
• After the activated sensor has been deactivated and hence the alarm case is confirmed, re-enter the
master code, respectively, the secondary security code or press the "deactivation" key (22) on your
radio remote control. The burglar alarm is in normal operation mode, now, and can be operated as
desired.

11.4.2 Deactivation of the burglar alarm (panic alarm)

Please note section "11.5 Panic alarm".
11.4.3 Silent Alarm with the Duress Code
You can carry out a so-called silent alarm by entering the duress code instead of the master code or the
secondary security code. In this case, the entry delay (30 seconds beep tone when sensor activated) is
interrupted and the beep tone is correspondingly interrupted. The internal alarm dialler nonetheless dials
the programmed telephone numbers.
A so-called silent alarm can be activated by pressing the "ARM" key (3) in deactivated state follo-
wed entering of the duress code.
The factory setting for the duress code is: 3838
11.5 „Panic Alarm"
You can set off a panic alarm by pressing the "PANIC" key (6) on your burglar alarm or by pressing the
"panic alarm" key (19) on your radio remote control. In this case the internal siren will sound the alarm
and call the programmed telephone numbers.
To deactivate the internal sirens and the burglar alarm, enter the master code, or the secondary security
code, or press the "deactivation" key (22) on your radio remote control. The internal siren is now deacti-
vated and the remaining telephone numbers are not called anymore.
You can also enter the duress code. In this case the acoustic alarm signals will be suppressed.
Nonetheless the programmed telephone numbers will still be dialled.
69