Product Identification; Information - AERMEC FCX P Manuel D'utilisation Et D'installation

FCX P-PE-PO-PV
14.

PRODUCT IDENTIFICATION

The FCX fan coils can be identified through:
− PACKAGING LABEL
Located on the packaging, it indicates the product identification data.
− TECHNICAL PLATE
Located inside the unit, it indicates the identification and technical data of
the product.
packaging label
example of packaging label
15.

INFORMATION

TRANSPORT
Refer to the weight indications
on the data plate to transport the
unit safely.
Take the following measures dur-
ing transport:
• The unit and the accessories must
not undergo violent impacts in order
not to affect the integrity of the
structure and of the internal compo-
nents;
• during transportation, the unit and
any accessories must be protected
in order to prevent impacts, for
this reason they must be properly
secured on the transportation floor
with ropes or any other means that
prevent their movement;
• during transport and storage,
the unit and the accessories must
always be protected against bad
weather.
IFCXPLJ 1412 - 6456063_01
VERIFICATIONS UPON RECEPTION
Visually check the unit upon re-
ception to make sure that:
• the order corresponds with what
is indicated in the transport docu-
ments;
• packaging is intact;
• the unit is intact;
• all the components have been
provided.
Indicate any damage or missing
components on the transport
document.
HANDLING
ATTENTION! : Wear proper per-
sonal protective equipment (PPE)
during handling operations.
Fully remove the unit and the
components from the packaging
before installation and use.
INSTALLATION
Read this sheet carefully; the
ATTENTION:
removal, the lack of the
identification plate does
not allow the product to
be safely identified and will
complicate any installation
or maintenance operations.
technical plate
xxxxxxxxxx
Volt
example of technical plate
execution of all works must be
performed by experienced and
qualified staff with specific tech-
nical skills, according to Standards
in force on this subject in the
installation country.
Comply with the installation in-
structions provided in the follow-
ing paragraphs. The paragraphs
follow a chronological order to
facilitate installation.
Retrieve the documents (manuals
and declarations of conformity)
and the components required to
complete installation from inside
the unit.
Aermec accessories are supplied
complete with a manual for in-
stallation and use.
Aermec accessories are designed
to be integrated into Aermec
units both for functional aspects
EN
Tampering,
21