Zanussi ZBB28430SL Notice D'utilisation page 20

Problem
Water flows on the rear plate
of the refrigerator.
Water flows inside the refriger-
ator.
Water flows on the floor.
The temperature in the appli-
ance is too low/too high.
If the advice does not lead to the
desired result, contact the nearest
Authorised Service Centre.
REPLACING THE LAMP
CAUTION! Disconnect the plug from
the mains socket.
1. Pull the left side of the lamp cover with your
fingers to unlock it. Remove the cover by
pulling it towards yourself.
20
Possible cause
Temperature is set incorrect-
ly.
During the automatic de-
frosting process, frost melts
on the rear plate.
The water outlet is clogged.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
The food products' tempera-
ture is too high.
Many food products are stor-
ed at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
There is no cold air circula-
tion in the appliance.
2. Replace the lamp with one of the same power
and shape, specifically designed for household
appliances. The maximum power is shown on
the light bulb cover.
3. Install the lamp cover.
4. Connect the plug to the mains socket.
Solution
Refer to "Operation" .
This is correct.
Clean the water outlet.
Make sure that food products do
not touch the rear plate.
Attach the melting water outlet to
the evaporative tray.
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products tempera-
ture decrease to room tempera-
ture before storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessary.
Make sure that there is cold air
circulation in the appliance.
1
2
1