Télécharger Imprimer la page

Zanussi ZBB28430SL Notice D'utilisation page 15

Publicité

Les langues disponibles

Les langues disponibles

Do not touch the compressor or the condenser.
They are hot.
Do not remove or touch items from the freezer
compartment if your hands are wet or damp.
Do not freeze again food that has been thawed.
Obey the storage instructions on the packaging
of frozen food.
INTERNAL LIGHT
The type of lamp used for this appliance is not
suitable for household room illumination
CARE AND CLEANING
WARNING! Risk of injury or damage
to the appliance.
Before maintenance, deactivate the appliance
and disconnect the mains plug from the mains
socket.
This appliance contains hydrocarbons in the
cooling unit. Only a qualified person must do the
maintenance and the recharging of the unit.
OPERATION
SWITCHING ON
1. Insert the plug into the wall socket.
2. Turn the Temperature regulator clockwise to a
medium setting.
SWITCHING OFF
To turn off the appliance, turn the temperature
regulator to the "O" position.
TEMPERATURE REGULATION
The temperature is regulated automatically.
A medium setting is generally the most
suitable.
However, the exact setting should be
chosen keeping in mind that the
temperature inside the appliance
depends on:
room temperature,
how often the door is opened,
the quantity of food stored,
the location of the appliance.
DAILY USE
WARNING! Refer to Safety chapters.
Regularly examine the drain of the appliance and
if necessary, clean it. If the drain is blocked,
defrosted water collects in the bottom of the
appliance.
DISPOSAL
WARNING! Risk of injury or
suffocation.
Disconnect the appliance from the mains
supply.
Cut off the mains cable and discard it.
Remove the door to prevent children and pets
to be closed inside of the appliance.
The refrigerant circuit and the insulation
materials of this appliance are ozone-friendly.
The insulation foam contains flammable gas.
Contact your municipal authority for information
on how to discard the appliance correctly.
Do not cause damage to the part of the cooling
unit that is near the heat exchanger.
1. Turn the Temperature regulator toward lower
settings to obtain the minimum coldness.
2. Turn the Temperature regulator toward higher
settings to obtain the maximum coldness.
CAUTION! If the ambient temperature
is high or the appliance is fully loaded,
and the appliance is set to the lowest
temperatures, it may run continuously
causing frost to form on the rear wall.
In this case the dial must be set to a
higher temperature to allow automatic
defrosting and therefore reduced
energy consumption.
CLEANING THE INTERIOR
Before using the appliance for the first time, the
interior and all internal accessories should be
washed with lukewarm water and some neutral
15

Publicité

loading