Peg-Perego seat unit Notice D'emploi page 9

TO FIT AND REMOVE THE SEAT
Before fitting and removing the seats, always apply the
brake.
4• To fit the seat to the frame, place it as shown in the figure
and press down with both hands till it clicks. The seat can
be mounted facing the mother or outwards.
5• To remove the seat pull the Ganciomatic lever in the
direction of arrow A and simultaneously press in direction
of arrow B and pull the seat upwards.
TO ADJUST THE BACKREST
6• The seat backrest reclines to four positions. To raise or
lower the backrest, pull up the lever and lock it in the
desired position.
TO ADJUST THE FOOTREST
7• A: The footrest can be adjusted in two positions, high
and low: The baby lies when the footrest is in the higher
position and seats when it is in the lower position. To
adjust the footrest, see the figure. B: The leg rest can be
raised only as shown in the figure, leaving the footrest
lowered.
SAFETY BELT
8• A: Make sure that the brace is properly inserted by
pushing as shown in the figure. B: Fasten the belt as
shown in the figure.
9• To unfasten the belt, press on the buckle sides and pull
out the waist strap.
10• The new safety belt is now easier to fasten thanks to the
"snap-open-and-shut" device. Before fastening the safety
belt, attach the buckle to the backrest by inserting the tab
through the special holder, as shown in the figure. After
fastening the safety belt on your child, detach it from the
backrest to allow the child more freedom of movement.
The buckle must remain below the child's shoulders.
REMOVABLE FRONT BUMPER BAR
When the children grow up, you can remove the front
bumper bar.
11• Remove the plugs from the armrests, pushing from
underneath with one hand and detach the front bumper
bar.
12• Remove the front bumper bar squared bushes pulling
them upwards and insert them into the armrests, taking
care that the solid side faces outwards; complete the
fitting replacing the plugs into the armrests.
HOOD
13• To attach the hood, insert the hooks into the armrests on
the seat and button it behind the backrest.
14• For the Duette and Triplette Seat Unit only: button the
lower hood tabs to the inside of the seat, as shown in the
figure. Lower the braces to tighten the hood.
15• For the Duette and Triplette Seat Unit only: the hood
comes with a zipper. With the zipper open, the hood can
be used as a canopy.
• To remove the hood, press the red button on the armrest
while pulling the hood attachment upward.
COVER
16• The cover can be attached when the hood is on the seat.
Place the cover on the seat and button it to the hood.
The cover comes with buttons to use with the footboard
lowered.
REMOVABLE LINING
17• To remove the lining from the seat, loosen the sack from
the armrests by opening the four hooks and lifting the
side tabs out of the hooks, as shown in the figure.
18• Loosen the side buttons at the bottom, as shown in the
figure. Slip the leg divider out from under the seat.
19• Slip the sack tab out from under the backrest, as shown in
the figure. Remove the sack from the top, pulling it over
the safety belt.
accessory line
20• Cover All Rain Canopy: Rain canopy made of transparent
PVC, covers the entire seat.
21• Diaper Bag: Bag with pad for changing baby's diaper.
Fastens to the carriage.
cleaning & maintenance
• Your product requires only minimal maintenance.
Cleaning and maintenance operations must be performed
only by adults.
• Be sure to keep all moving parts clean, lubricating them
with light oil if necessary.
• Regularly clean the plastic parts with a damp cloth. Do
not use solvents or similar products.
• Brush the fabric parts to remove dust.
• Protect the product against smog, water, rain and snow.
Continued and extended exposure to sunlight can
change the colours of many materials.
• Store the product in a dry area.
• To wash the lining, carry out the following instructions.
assistance service
If parts of the product are lost or damaged, replace only
with original Peg-Pérego spare parts. For any repairs,
replacements, product information and the sale of original
spare parts and accessories contact the Peg-Pérego
Assistance Service:
• tel.: 0039 039 60 88 213
• fax: 0039 039 33 09 992
• e-mail: assistenza@pegperego.it
• web site: www.pegperego.com
Peg-Pérego may modify the products described in this
publication at any time for technical or commercial
reasons.
what do you think of us?
Peg-Pérego makes itself available to all its customers in
order to best satisfy their various needs. Knowing the
opinion of our customers is extremely important and
valuable to us. We would therefore be very grateful if,
after using our product, you would fill in the CONSUMER
SATISFACTION QUESTIONNAIRE, adding any observations
or suggestions, on our web site: www.pegperego.com