HumanTechnik LISA TX Mode D'emploi page 10

It is only necessary to set units to
other channels if you have several
different users operating units in the
same building.
Set the required channel by using a
small screwdriver to turn the channel
selector switch, which is located
towards the top of the battery com-
partment, to the required channel
number.
All transmitters and receivers must
be set to the same channel.
Fig. Setting the correct radio chan-
nel.
3. Installing the alarm accessories
Plug the alarm accessories into the
socket on the underside of the RF
alarm transmitter .
This socket is identified by a triangle
framing an exclamation mark:
10 English
Please note:
A separate socket must be used for
the water alarm sensor.
This socket is marked with a double
wave.
Available accessories:
Alarm mat (A-2921-0)
Connect the plug from the alarm mat
directly into the socket in the RF
alarm transmitter (alarm accessories
socket). Place the alarm mat under
the doormat.
Alarm call button (A-2935-0)
Connect the plug from the alarm call
button directly into the socket in the
RF alarm transmitter (alarm accesso-
ries socket). The alarm signal is trig-
gered by pressing the button (e.g.
from the patient's bed).
Water alarm sensor (A-2924-0)
Plug the water alarm sensor into the
socket of the transmitter marked with
a double wave. The water alarm sen-
sor is suitable for nearly all fluids.
Stick the sensor with the supplied
double-sided adhesive tape to the
wall so that the contacts touch the
floor. The signal is triggered as soon
as both contacts are wetted by the
fluid.