Festool TKS 80 EBS Notice D'utilisation D'origine page 34

English
The green
LED [2-4] flash­
es rapidly.
The red
LED [2-5] lights
up constantly.
8.2 Activating the SawStop technology
The SawStop technology is activated upon
delivery and after each time the saw is put
back into operation.
► Press the red STOP button [2-2].
The SawStop technology is activated.
8.3 Bypass mode (deactivated SawStop
technology)
Only use bypass mode to saw conductive
materials. Activate the SawStop technolo­
gy again once finished.
Activating bypass mode
► Press and hold the yellow SawStop
switch [2-6].
The red LED [2-5] flashes once, and then im­
mediately
► press the green START button [2-3].
The TKS 80 EBS starts up.
The red LED [2-5] flashes again once.
► Release the yellow SawStop switch [2-6]
and the green START button [2-3].
The green LED [2-4] flashes slowly.
The red LED [2-5] is not lit.
The TKS 80 EBS is ready for use in bypass
mode.
Deactivating bypass mode (activating the
SawStop technology)
► Press the red STOP button [2-2].
The SawStop technology is activated.
34
The saw blade comes
to a stop during saw­
ing.
Switch the
bench-mounted cir­
cular saw off and on
and saw the work­
piece more slowly.
Or:
The bench-mounted
circular saw is opera­
tional and the yellow
SawStop switch has
been pressed.
Switch the
bench-mounted cir­
cular saw off and on.
8.4 Checking the conductivity of the
material
The conductivity of the material can be checked
in advance without triggering the SawStop tech­
nology.
► Press the green main switch [2-1].
The TKS 80 EBS is ready to use.
► Position the material against the saw blade.
The green LED [2-4] lights up constantly.
The red LED [2-5] flashes rapidly.
Material is conductive: Work in bypass mode
(see section 8.3 ).
The green LED [2-4] lights up constantly.
The red LED [2-5] is not lit.
Material is not conductive: Work with SawStop
technology active (see section
8.5 Triggered SawStop technology
WARNING
Risk of injury due to uncontrolled start-up of
the bench-mounted circular saw
► Always disconnect the mains plug from the
socket before performing any work on the
machine.
Return information for triggered SawStop
technology
The cartridges save electronic data measured
when the technology was triggered. If you re­
turn the activated cartridge to Festool, we can
retrieve that data to analyze how the electron­
ics and software performed.
If we confirm that your cartridge activated due
to skin contact, you get the chance to receive a
free replacement cartridge. Festool reserves
the right to decide about such cases individual­
ly.
Please let us know your name and a contact op­
portunity (email address, phone number, ad­
dress), so that we can get in touch with you by
phone or in writing.
For information on data protection at Festool
please check our website: www.festool.co.uk
Changing the cartridge and saw blade
When the SawStop technology is triggered, the
cartridge drives an aluminium block into the
saw blade and the saw blade comes to a stop
under the table.
8.2 ).