Transportation; Sawstop Technology - Festool TKS 80 EBS Notice D'utilisation D'origine

English
The green LED [2-4] lights up constantly.
The red LED [2-5] is not lit.
The TKS 80 EBS is in standby mode.
► Press the green main switch [2-1].
The TKS 80 EBS is non-operational.
7

Transportation

CAUTION
Heavy bench-mounted circular saw
Risk of injury
► The bench-mounted circular saw must be
carried by two people.
► Hold it by the handle areas on the
side [3-3] for transport. Never take hold of
and transport the power tool by the guard.
► Store the accessories included in the scope
of delivery in the accessory holders or the
brackets provided for that purpose
(Fig. 3a, 3b, 3c).
Accessory holder
Spacer wedge with guard
Spacer wedge for grooving
Cartridge
Push stick
Preset profile setting rail
(Take note of the adjustment
markings [3-6] for storing the
preset profile setting rail.)
Power cable
Power cable brackets
Power cable
Tool
Hex key
Spanner for the spindle flange
Spanner for the spindle nut
► Remove accessories not included in the
scope of delivery.
► Fold in the foldaway legs (see section
The TKS 80 EBS can be transported.
7.1 Transport rollers
The TKS 80 EBS is equipped with transport roll­
ers [1-20] for moving it over short distances.
► Hold the TKS 80 EBS by the handle areas on
the side [1-2] and pull it into the required
position.
32
8

SawStop technology

The SawStop technology can prevent the most
serious cutting injuries.
The core component of the SawStop technology
is a cartridge that drives an aluminium block
into the saw blade with the aid of a spring. The
mechanism is triggered by a capacitative sen­
sor when it comes into contact with human skin
or any other conductive materials during opera­
tion.
The SawStop technology only works with a pro­
tective earth connection and an earthed power
source. Make sure that power is not supplied
via the SYS PowerStation or a transformer, for
example.
Working with the TKS 80 EBS is only possi­
ble if the cartridge is inserted.
Noise generated when the SawStop technol­
ogy is triggered
Risk of accidents
[3-1]
► Use ear protection.
[3-2]
[3-4]
SawStop technology is triggered
[3-5]
► Do not let the saw blade come into contact
[3-7]
with the stopper or the cross stop.
SawStop technology is triggered or
the TKS 80 EBS does not start.
[3-8] Distance between saw blade and fence too
small.
[3-9]
► When sawing cutting widths of ≤ 3 mm, use
a support ≥ 19 mm.
[3-10]
8.1 Function monitoring
[3-11]
The SawStop technology continuously moni­
[3-12]
tors the regular operation of the saw. The
LED lights show the current operating status.
LED status in standby
6.1 ).
The green
LED [2-4] lights
up constantly.
The red
LED [2-5] flash­
es slowly.
WARNING
NOTICE
NOTICE
The bench-mounted
circular saw starts up
in approx. 10 sec­
onds.