Maintenance; Disposal And Recycling; Possible Causes Of Failure - Scheppach HCE2000 Traduction Des Instructions D'origine

13. Maintenance

m Warning! Pull out the mains plug before carrying
out any adjustments, maintenance or repair work!
General maintenance tasks
• Keep protective devices, air vents and the motor
housing as free of dust and dirt as possible. Rub
the device clean with a clean cloth or blow it off with
compressed air at low pressure.
• We recommend that you clean the device directly
after every use.
• Clean the device at regular intervals using a damp
cloth and a little soft soap. Do not use any cleaning
products or solvents; they could attack the plastic
parts of the device. Make sure that no water can
penetrate the device interior.
Long service life of the electric pump
If longer downtimes of the machine (more than 3
months) are planned in rooms where there is a risk
of frost, it is advisable to fill the machine with an anti-
freeze (similar agent as used for vehicles).
If the device has not been used for a long time, lime-
scale builds up in the electric pump, which can lead
to starting difficulties.
Service information
With this product, it is necessary to note that the fol-
lowing parts are subject to natural or usage-related
wear, or that the following parts are required as con-
sumables.
Wearing parts*: Belt, hose, lance, nozzles and at-
tachments, air filters, seals
* may not be included in the scope of supply!
Spare parts and accessories can be obtained from
our service centre. To do this, scan the QR code on
the cover page.

15. Possible causes of failure

Malfunction Cause
No electrical voltage on the device.
The conductor cross-section of the
extension lead is too small or the
Device does not
extension lead is too long.
work.
Mains voltage is below the specified
value
Pump is frozen.
Motor runs, but no
Intake of air in the water supply.
pressure is built
up.
Outlet nozzle too large.
Irregular operating
Intake of air in the water supply.
pressure.
24 | GB
Cleaning the nozzle (Fig. 1)
To clean a clogged nozzle, please use the nozzle
cleaner needle (11) provided.

14. Disposal and recycling

The device is supplied in packaging to avoid
transport damages. This packaging is raw
material and can thus be used again or can
be reintegrated into the raw material cycle.
The device and its accessories are made
of different materials, such as metals and plastics.
Take defective components to special waste disposal
sites. Check with your specialist dealer or municipal
administration!
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
handed over at the intended collection point. This
can be done, for example, by returning it when pur-
chasing a similar product or delivering it to an au-
thorised collection point for the recycling of old elec-
trical and electronic devices. Improper handling of
waste equipment may have negative consequences
for the environment and human health due to poten-
tially hazardous substances that are often contained
in electrical and electronic equipment. By properly
disposing of this product, you are also contributing
to the effective use of natural resources. You can
obtain information on collection points for waste
equipment from your municipal administration, pub-
lic waste disposal authority, an authorised body for
the disposal of waste electrical and electronic equip-
ment or your waste disposal company.
Remedy
Check fuse, mains cable, mains plug and have
them replaced by qualified personnel if necessary.
Use extension leads with a larger wire cross-
section or use shorter extension leads.
Contact the energy supply company if necessary.
Check, defrost if necessary.
Check supply hose and hose connections, replace
if necessary.
Check, replace if necessary.
Check supply hose and hose connections, replace
if necessary.
www.scheppach.com