Cleaning And Maintenance - Mobicool MB 40 AC/DC Notice D'utilisation

Mobicool DC/AC
I
NOTE
Disconnect the cooler from the battery when the engine is not run-
ning, as otherwise the battery will run down.
Connecting the cooler to 230 V (compressor mode)
➤ Connect the 230 V connection cable (fig. 1 3, page 2) to the 230 V AC
mains supply.
➤ Open the lid of the thermostat (fig. 2 3, page 2) by pressing down on it.
I
NOTE
Press down on the lid again to close it.
➤ Turn the thermostat (fig. 2 3, page 2) clockwise to the required position.
I
NOTE
The further you turn the thermostat towards "MAX", the lower the
refrigerating temperature.
✔ The cooler starts cooling the interior.
➤ To switch off the cooler:
– Turn the thermostat (fig. 2 3, page 2) anti-clockwise to "0".
– Disconnect the plug.
– Wind the cable around the two holders on the back of the device for
storage.
7.3 Connecting to vehicle power
I
NOTE
If you connect the cooling device to the vehicle power, remember
that you may have to turn on the ignition to supply it with power.
8

Cleaning and maintenance

A
NOTICE! Damage hazard
 Never clean the cooler under running water or in dish water.
 Do not use abrasive cleaning agents or hard objects during
cleaning as these can damage the cooler.
EN
Cleaning and maintenance
11