Assembly - Husqvarna LC 141VLi Manuel D'utilisation

seconds before you start the
maintenance.
For model LC 141C: To
•
prevent accidental start during
maintenance, disconnect the
power cord.
Do the maintenance work
•
correctly to increase the
lifetime of the product and
decrease the risk of accidents.
Let an approved service agent
do the professional repairs.
Speak to your nearest service
agent for more information.
Only do the maintenance work
•
written in this operator's
manual. More extensive work
must be done by an approved
service agent.
Put on heavy duty gloves
•
when you use the cutting
equipment. The blade is very
sharp and cuts can easily
occur.
Introduction
WARNING: Before you assemble the
product, read the safety chapter.
WARNING: For models LC 141VLi and
LC 141Li: To prevent accidental start during
assembly, turn the safety key to 0, remove
the battery and wait at minimum 5 seconds.
For model LC 141C: To prevent accidental
start during assembly, disconnect the power
cord.
71 - 005 - 18.05.2018
Keep the cutting edges sharp
•
and clean for the best and
safest performance.
Let your service agent
•
regularly examine the product
and make necessary
adjustments and repairs.
Replace damaged, worn or
•
broken parts.
Obey the instructions for how
•
to change accessories. Only
use accessories from the
manufacturer.
When not in operation, keep
•
the product, battery and
battery charger apart in a dry,
indoor and locked area. Make
sure that children and persons
that are not approved cannot
get access to the product,
battery or battery charger.

Assembly

To assemble the handle
1. Align the holes in the handlebar with the holes in the
lower handle and attach the screws, washers and
knobs. Tighten the knobs fully.(Fig. 33 )
2. Attach the cables to the handle with the cable
holders.(Fig. 34 )
Note: Make sure that the tension in the cables is not
too high. A too high tension can cause damage to
the cable if the handle is folded to transport position.
3. Put the cables around the hook at the bottom of the
handle.(Fig. 35 )
To adjust the handle height
1. Loosen the lower knobs.(Fig. 36 )
19