Assembly; Fitting The Loop Handle; Fitting The Trimmer Guard And Trimmer Head - Husqvarna 122C Mode D'emploi

Fitting the loop handle

• Clip the loop handle onto the shaft. Note that the loop
handle must be fitted between the arrows on the shaft.
• Fit the bolt, securing plate and wing nut as shown in
the diagram. Tighten the wing nut.
Fitting the trimmer guard and
trimmer head
(122LK)
• Fit the correct trimmer guard (A) for use with the
trimmer head. Hook the trimmer guard/combination
guard onto the fitting on the shaft and secure with the
bolt (L).
• Fit the drive disc (B) on the output shaft.
• Turn the output shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
• Insert the locking pin (C) in the hole to lock the shaft.
10 – English

ASSEMBLY

• Screw on the trimmer head (H) in the opposite
direction to the direction of rotation.
• To dismantle, follow the instructions in the reverse
order.
Fitting the trimmer guard and
trimmer head
(122C)
• Fit the guard as shown in the diagram. Tighten
securely.
• Fit the dust cup on the shaft. The nut must be
completely covered by the dust cup.
• Hold the dust cup with a spanner to prevent the shaft
from rotating.
• Screw the trimmer head onto the shaft.