Maintenance - Husqvarna LC 141VLi Manuel D'utilisation

To start the product
1. Connect a power cord to the socket below the
handle.(Fig. 61 )
2. Put the power cord in the power cord holder. Refer
To use the power cord holder (model LC 141C) on
to
page 16 .(Fig. 62 )
3. Stay behind the product.
4. Loosen the start inhibitor.(Fig. 63 )
5. Push the motor brake handle in the direction of the
handlebar.(Fig. 64 )
To stop the product
1. Release the motor brake handle to stop the motor.
(Fig. 65 )
2. Disconnect the power cord from the mains and then
from the product.(Fig. 66 )
Introduction
WARNING: Before you do maintenance, you
must read and understand the safety
chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
LC 141VLi, LC 141Li and LC 141C
Do a general inspection.
Clean the product.
Do a check of the start inhibitor *.
Make sure that the safety devices on the product are not defective *.
Examine the cutting equipment.
Examine the cutting cover *.
Do a check of the motor brake handle *.
LC 141VLi and LC 141Li only
Make sure that the ON/OFF button operates correctly and is not defective.
Examine the battery for damage.
Do a check of the battery charge.
Make sure that the release buttons on the battery operates correctly and that the
battery locks into the product.
22
To get a good result
• Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
• Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
• Cut in different directions each time to prevent
stripes in the lawn.

Maintenance

Maintenance schedule
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with *, refer to
on the product on page 16 .
CAUTION: Pull the plug straight out. Do
not pull the power cord.
Daily Weekly
X
X
X
X
X
X
X
Daily Weekly
X
X
X
X
71 - 005 - 18.05.2018
Safety devices
Monthly
Monthly