Vermeiren Carpo 2 Mode D'emploi page 27

Check all around on both sides that the tube is not pinched between the rim and the edge of the tyre.
Lightly push the air valve inwards and pull it out again to make sure that the tyre is positioned properly
in the region of the air valve.
To ensure that the wheel is inflated correctly, admit only so much air initially that the tyre can still be
easily pushed inwards by using your thumbs. If the check-lines are equidistant from the edge of the
rim on both sides of the tyre, then the tyre is centered properly. If not - let out the air and position the
tyre afresh. Now the tyre can be inflated to its full operating pressure (note the maximum) and the
valve cap should be replaced.
Only an expert can guarantee correct assembly. Work not done by your specialist dealer, would void
any warranty claims.
When inflating the tyres, always check that the pressure is correct. The correct pressure is given on
the tyre walls.
Use only inflating equipment which complies with regulations and indicates the pressure in bar. We do
not accept any liability for damage caused by using inflation equipment not supplied by the
manufacturer.
DISMANTLING
1. Unscrew and remove the 5
2. Let the air out of the wheel
3. Unscrew the 5 screws Ⓔ of
ASSEMBLY
Insert the partly-filled inner tube
into the tyre.
1. Connect the two sides of the
2. Put the valve Ⓓ through the
3. Put the wheel Ⓑ back on
Page 25
Carpo 2
2015-07
screws Ⓐ that attach the
wheel Ⓑ to the flange Ⓒ.
by lightly pressing
pressure pin on the valve Ⓓ.
the rim. Separate the rim
sides.
rim through the tyres and
screw them back again with
the 5 screws Ⓔ.
hole for it in the rim.
the flange Ⓒ and secure
these connection with the 5
screws Ⓐ. Inflate the wheel
to the recommended tyre
pressure.
the