To resume your uphill drive, push the accelerator throttle open fully to ensure the release of a
sufficient amount of power. This will allow your scooter to slowly ascend the slope.
If your scooter is unable to drive up, turn the speed control up and try again.
When driving on a gradient, the battery indicator light might move up and down. This is a normal
phenomenon so please do not worry.
2.7.7 Going downhill
L
WARNING:
Control your scooter - Accustom yourself with the driving behavior of your
scooter.
L
WARNING:
Control your scooter - Never put your scooter in neutral on slopes.
L
WARNING:
Control your speed - Moving on slopes as slow as possible.
L
WARNING:
Risk of tipping over - Avoid sharp bends.
L
WARNING:
Risk of tipping over - Do not exceed the maximum gradient of static
stability downhill (see paragraph "Technical specifications").
Always approach downhill slopes directly from the front. Slantwise approaches can lead to some of
the wheels no longer staying in contact with the ground (danger of tipping over). If one of the back
wheels fails to make contact, the transmission of power will be cut and the scooter come to a
standstill.
The weight of the scooter will increase your downhill speed. Turn the speed control down and adjust
your speed to the conditions.
Avoid sharp bends on downhill slopes. The weight of your scooter could cause your scooter to lift up
on one side or even fall over around bends.
2.8
Driving the scooter on ramps
L
WARNING:
Risk of injury - Do not exceed the maximum load of the ramps.
L
WARNING:
Risk of injury - Choose the correct ramps so there cannot be caused any
injury or damage.
L
WARNING:
Risk of injury - Note that the considerable weight of the electric scooter
generated large reverse forces when an attendant is pushing the scooter over the
ramps.
L
WARNING:
Risk of injury - Be sure that the wheel height is high enough to get over the
free height of the ramps. The scooter frame may not touch the ramps.
Should you wish to use ramps to drive over an obstacle, please note the following:
1. Find out from the manufacturer what the maximum load is for the ramps.
2. Drive on the ramps at the lowest speed possible.
3. See the instructions in the chapter "your first trip".
Page 14
Carpo 2
2015-07