Stop Watch - Conrad Electronic 86 01 02 Notice D'emploi

13. Stop Watch

1
0
A
ST./STP.
0
B
ST./STP. ST./STP. ST./STP. ST./STP.
0
C
ST./STP. LAP/RESET LAP/RESET
0
t i m e
3
2
3 0
ST./STP.
2 0
1 0 1 0
1 0 2 0
10 20 30 40
• First change to the stop watch display mode (e.g. press the "MODE"
button repeatedly until the chronograph symbol "CH" (1) is displayed).
• The "ST./STP." button can be used to start and stop the stop watch
(2) (see "A" in the figure on the left). The maximum time which can
be measured is 9 hours, 59 minutes, 59.99 seconds.
• If the time measurement is to be continued, restart it with the
"ST./STP." button (see "B").
• With the "LAP/RESET" button you can, for example, display an
interim time, the time measurement continues on (see "C"); the
seconds and minutes symbols flash in the display in the upper right
next to the numbers.
If the "LAP/RESET" button is pressed again the current time
measurement is displayed again.
While the interim time is being displayed, you can press the
"ST./STP." and stop the internal time measurement. Briefly pressing
the "ST./STP" button allows you to then show the time measurement.
• If the time measurement is stopper with the "ST./STP." button, the
stop watch can be reset to "0:00:00" with the "LAP/RESET" button.
51