In1 (Wertebereich); In2 (Wertebereich); Pid-Parameter - Wilo Stratos GIGA Série Notice De Montage Et De Mise En Service

English
No. Designation
5.2.3.0 Bus address
5.2.4.0 IF gateway val A
5.2.5.0 IF gateway val C
5.2.6.0 IF gateway val E
5.2.7.0 IF gateway val F
5.3.0.0 IN1 (sensor input)
5.3.1.0 IN1 (sensor value
range)
5.3.2.0 IN1 (value range)
5.4.0.0 IN2
5.4.1.0 IN2 active/inactive
5.4.2.0 IN2 (value range)
5.5.0.0 PID parameters
5.5.1.0 P parameter
5.5.2.0 I parameter
5.5.3.0 D parameter
5.6.0.0 Fault
5.6.1.0 HV/AC
5.6.2.0 Emergency opera-
tion speed
5.6.3.0 Auto reset time
5.7.0.0 Other settings 1
5.7.1.0 Display orientation
104
Type Symbol Values/explanations
Setting of bus address
±
±
±
Specific settings of the IF-Module,
depends on protocol type
±
±
Settings for sensor input 1
Display of sensor value range 1
Setting of the value range
±
Possible values: 0...10 V/2...10 V/
0...20 mA/4...20 mA
Setting for external setpoint
input 2
ON
±
External setpoint input 2 active
OFF
External setpoint input 2 inactive
Setting of the value range
±
Possible values: 0...10 V/
2...10 V/0...20 mA/4...20 mA
Settings for PID control
Setting of the proportional term
±
of the control
Setting of the integral term of
±
the control
Setting of the derivative term of
±
the control
Settings for behaviour in case of
error
HV "heating" mode
±
AC "cooling/air-conditioning"
mode
Display of emergency operation
speed
Time until automatic acknowl-
±
edgement of an error
Display orientation
±
Display conditions
Further information can be
found in the installation and
operating instructions of the
IF-Modules.
Not displayed in the manual
control mode (incl. all sub-
menus)
Not displayed with PID con-
trol
Not displayed when IN2 =
inactive
Only displayed when PID
control is active (incl. all sub-
menus)
WILO SE 10/2017