Checking / Adjusting / Replacing V-Belt - HOLZMANN MASCHINEN TS315F1600 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

16.2.4 Checking / adjusting / replacing V-Belt

The V-belt tension is set correctly for new machines ex-factory. By stretching the belts over
the running time, retensioning of the V-belt is necessary.
For changing the V-belt, completely detension the V-belt and pull it over the tension pulleys
and insert a new belt. Then establish correct V-belt tension again.
Increase V-belt tension:
Loosen the 4 nuts (4) now the motor can
be shifted in the direction (+) of more V-
belt tension.
When correct tension is reached. Tighten
the 4 nuts (4) firmly again, and reinstall the
work table (2)
16.3 Storage
Improper storage can damage and destroy important machine parts. Store packed
or unpacked parts only under the intended ambient conditions!
In case of a longer interruption of operation or shutdown, clean the machine thoroughly and
then store it out of the reach of children in a dry environment protected from frost and other
weather influences!
HOLZMANN MASCHINEN GmbH
the nut with a wrench (7) counter clockwise.
NOTE
the nut from loosening during operation.
 Replace the front safety cover (5) and the table
insert (4) and retighten the screws to hold them in
place.
 Refit the sliding table (3) back into the desired
position.
 Fit the saw blade guard (1) on the riving knife (2).
NOTE
www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORGE, DISPOSAL
Retighten the nut tightly (70Nm) to prevent
 Loosen the allen screws (1) on both sides
below the work table.
 The work table together with the table ex-
tensions (length and width) (2) can now be
removed.
 The motor (3) is fixed by 4 screws.
 By loosening the 4 nuts (4), the motor po-
sition can be adjusted.
 Move the motor upwards (-) to release the
belt (5).
Decrease V-belt-tension:
Loosen the 4 nuts (4) now the motor can be
shifted in the direction (-) of less V-belt ten-
sion.
When correct tension is reached. Tighten the 4
nuts (4) firmly again, and reinstall the work
table (2).
50
TS315F1600

Publicité

Table des Matières
loading

Table des Matières