HOLZMANN MASCHINEN GmbH
www.holzmann-maschinen.at
4. Assembly table table support
Disassemble nuts (3) and washers (4) from
the large (1) and small table support (2).
Fix the large table support to the table ex-
tension (6) with 3 washers (3) and nuts (4)
each and to the work table (5) with one
washer (3) and nut (4).
Fix the small table support to the work ta-
ble (5) with 2 washers (3) and nuts (4)
each.
5. Assembly table extension (width)
Mount the table extension on both sides
with 2 screws (1), 4 washers (2) and 2 nuts
(3) to the table supports.
NOTE:
Before tightening the screws, align the
edge of the table extension as described in
point above (Assembly table extension –
length) with that of the work table.
Tighten the screws with a wrench.
ASSEMBLY
38
TS315F1600