HOLZMANN MASCHINEN TS315F1600 Mode D'emploi page 39

HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
6. Assembly rip fence
6.1. Ruler
 Adjust the measuring scale to the saw
blade and fix it to the work table with 5
screws (1) and washers (2).
NOTE: Make sure that the measuring scale is
adjusted to the saw blade and faces upwards.
6.2. Rip fence guide
 On each of the 5 threaded bolts (3) of the
rip fence guide 2 washers 2 nuts are loosely
screwed on.
 Remove a nut and a washer from each of
the 5 threaded bolts.
 Insert the threaded bolts (3) of the rip
fence guide into the boreholes on the work
table and the table extension (length).
 Put the previously removed washers (5) on
the threaded bolt and screw the nuts (4)
back on.
6.3. Assembly rip fence support
 Loosen the star screws (6) of the rip fence
support.
 Slide the rip fence support onto the rip
fence guide (7).
 Tighten the two star screws (6) again.
ASSEMBLY
39
TS315F1600