HOLZMANN MASCHINEN TS315F1600 Mode D'emploi page 35

 Do not work on the machine if you are tired, not concentrated or under the influence of
medication, alcohol or drugs!
 Do not use the machine in areas where vapours from paints, solvents or flammable liquids
represent a potential danger (danger of fire or explosion!).
 Do not smoke in the immediate vicinity of the machine (fire hazard)!
 Make sure that the ON-OFF-switch is in the "OFF" position before connecting the machine
to the power source.
 Do not use the machine if it cannot be switched on and off with the ON-OFF-switch.
 Always shut down the machine before carrying out any conversion, adjustment, measur-
ing, cleaning, maintenance or repair work and always disconnect it from the power supply
for maintenance or repair work. Before starting any work on the machine, wait until all
tools or machine parts have come to a complete standstill and secure the machine against
unintentional restarting.
12.5 Electrical safety
 Make sure that the machine is earthed.
 Only use suitable extension cords.
 A damaged or tangled cable increases the risk of electric shock. Handle the cable with
care. Never use the cable to carry, pull or disconnect the power tool. Keep the cable away
from heat, oil, sharp edges or moving parts.
 Proper plugs and sockets reduce the risk of electric shock.
 Water entry into machine increases the risk of electric shock. Do not expose machine to
rain or moisture.
 The machine may only be used in humid environments if the power source is protected by
a residual current circuit breaker.
 Do not use the power tool if it cannot be turned on and off with the ON-OFF-switch.
12.6 Special safety instructions for woodworking machines
 Work with gloves on rotating parts is not permitted!
 During operation of the machine wood dust is generated. Therefore, connect the machine
to a suitable dust collection system for dust and chips during installation!
 Always switch on the dust collection system before you start machining the workpiece!
 Never remove sections or other parts of the workpiece from the cutting area while the ma-
chine is running.
 When using milling tools with a diameter of ≥ 16 mm and circular saw blades, these must
comply with EN 847-1:2013 and EN 847-2:2013; tool carriers must comply with EN 847-
3:2013;
 Excessive noise can cause hearing damage and temporary or permanent hearing loss.
Wear hearing protection certified to health and safety regulations to limit noise exposure.
 Replace cracked and deformed saw blades immediately, they cannot be repaired.
 Use a push stick for cutting operations where less than 120mm is cut, i.e. less than
120mm distance to the right of the saw blade from the rip fence. Do not feed the wood by
hand, only with the push stick!
 Select the number of teeth of the saw blade so that at least 2-3 teeth cut through the
workpiece at the same time. A lower number of teeth leads on the one hand to an unclean
cut, on the other hand the danger of vibrations and noise pollution increases due to in-
creased kickback.
12.7 Hazard warnings
Despite its intended use, certain residual risks remain. Due to the design and construction of the
machine, hazardous situations may occur when handling the machines, which are identified as
follows in this operating instruction:
A safety instruction designed in this way indicates an imminently hazardous situa-
tion which, if not avoided, will result in death or serious injury.
Such a safety instruction indicates a potentially hazardous situation which, if not
avoided, may result in serious injury or even death.
A safety instruction designed in this way indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate injury.
HOLZMANN MASCHINEN GmbH
DANGER
WARNING
CAUTION
www.holzmann-maschinen.at
SAFETY
35
TS315F1600