Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5.2 Working / Measurement reference
All measurements use the rear edge of the laser range meter as the
reference point.
▶ Hold the rear edge of the laser range meter against the point from which
the measurement is to be taken.
5.2.1 Taking single measurements
1. Press the ON / Delete / OFF button to activate the laser beam.
2. Aim
the
laser
Measure / Continuous measurement button.
▶ The distance is shown in the display.
Press the ON / Delete / OFF button once to delete the last measured
values.
Press the ON / Delete / OFF button again to return from area mea-
surement to distance measurement.
5.2.2 Switching the continuous measuring mode on and off
1. Press the Measure / Continuous measurement button for 2 seconds to
activate continuous measurement.
▶ The distance is shown in the display.
2. Press the Measure / Continuous measurement button again to end the
continuous measurement.
5.2.3 Measuring area
1. Switch on the product. → page 5
2. Short-press the Area measurement / Units button.
3. Measure
the
Measure / Continuous measurement button.
4. Measure
the
Measure / Continuous measurement button.
▶ The area is calculated and the result is shown on the display.
5.2.4 Changing units
▶ Press the Area measurement / Units button for 2 seconds to toggle from
one unit of measurement to the other.
6
Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable
to remedy the problem by yourself, please contact Hilti Service.
6
English
6
beam
at
the
4
length
of
the
width
of
the
8
target
and
area
by
pressing
area
by
pressing
2190183
*2190183*
press
the
5
the
the
Publicité
Table des Matières
