Hilti PD-S Mode D'emploi page 10

▶ Comply with national health and safety requirements.
2.3 Proper arrangement of the workplace
▶ Avoid unusual postures when working on ladders. Maintain firm footing
and balance at all times.
▶ Secure the site where you are taking measurements and when using the
product do not direct the laser beam toward other persons or toward
yourself.
▶ When the product is brought into a warm environment from very cold
conditions, or vice-versa, allow it to become acclimatized before use.
▶ Use the product only within its specified limits.
▶ Keep the laser aperture clean to avoid measurement errors.
▶ Comply with the national accident prevention regulations.
2.4 Laser classification for Class 2 laser products
The device complies with Laser Class 2 in accordance with IEC 60825-
1:2014 /EN 60825-1:2014. These devices can be used without further
protective measures.
CAUTION
Risk of injury! Do not direct the laser beam toward persons.
▶ Never look directly into the source of the laser beam. In the event of direct
eye contact, close your eyes and move your head out of the path of the
laser beam.
3 Description
3.1 Product overview
Display
@
;
Measure / Continuous
measurement button
Display
Battery status indicator
&
Last measured value
(
Units
)
3.2 Intended use
The product described is a laser range meter. It is designed for single
measurements and for continuous measurement of distances.
Distances can be measured relative to all objects with a surface consisting of
any normally laser-reflecting material such as concrete, stone, wood, plastic
or paper. The use of prisms or other highly reflective targets is impermissible
and, if attempted, can falsify the results.
4 English
1
=
%
+
§
Area measurement / Units
button
ON / Delete / OFF button
Current measured value
Measurement reference
2190183
*2190183*