Before commissioning
Safety
Utilisation in
Read the user guide carefully. If there are any uncertainties, please contact
accordance with
akkuteam or a qualified person. Connect red clamp to (+) and black clamp
„intended
to (-). The charger is intended for use with lead/acid, AGM, EFB, GEL and
purpose"
Lithium-Ion batteries. The battery manufacturer's recommendation shall
always be taken into consideration. NB: To make sure the correct charging
voltages are applied to the battery the charging cables must not be
shortened or made longer.
The charger is only to be used for charging batteries as described in
the „Technical data" section and is intended exclusively for supporting
the electrical systems of cars in showrooms. Any other from of usage is
deemed „not in accordance with the intended purpose". The manufac-
turer shall not be liable for any damage resulting from such improper
use. Utilisation in accordance with the „intended purpose" also includes
– following all the instructions in these operating instructions
– regular checking of mains and charging cables
Mains connection
The rating plate, which is located on the housing, contains information
about the permitted mains voltage. The charger is designed for this
mains voltage only. The fuse protection required for the mains lead can
be found in the „Technical data" section. If there is no mains cable or
mains plug on your machine, fit one that conforms to national standards.
WARNING! Operating the equipment incorrectly can
cause serious injury and damage. Do not use the functions
described until you have thoroughly read and understood
the following documents:
– Operating instructions
– All the operating instructions for the system components,
especially the safety rules
– Battery and vehicle manufacturers' operating instructions
and safety rules
WARNING! Charging dry batteries (primary cells) and non-
rechargeable batteries can cause serious injury or damage,
and is therefore prohibited.
46
EN