EINHELL Air-Tech 300/50 W Mode D'emploi page 7

2288-Air-Tech-Kompressoren
Before use, please read the instructions carefully.
Technical data
Power supply
Engine rating kW/PS
Compressor speed min
Operating pressure bar
Pressure vessel volume (in liters)
Effective delivery at 6 bar l/min.
Induction capacity l/min.
Art. no.
Itern no.
The equipment is suppressed in accordance with EC Directive 82/499 EC.
Notes on installation
G Check the equipment for
damage during transport.
Any damage should be reported
immediately to the freight com-
pany who delivered the com-
pressor.
G Before starting up, check the oil
level in the compressor pump.
G The compressor should be set
up near to the consumer unit.
G Avoid long air pipes and long
leads (extensions).
G Ensure intake air is dry and free
from dust.
G Do not install compressor in a
damp or wet room.
G The complete compressor has
already been sample-tested.
Further inspection before use by
a TÜV specialist is not neces-
sary. The enclosed factory and
test certificates must be retained.
G If the system is inspected by an
expert from the Industrial Super-
visory office of the Professional
Association, these certificates
must be produced. See also
manufacturer's certificate "Notes
for the Operator".
13.11.2001 14:18 Uhr
230 V ~ 50 Hz
-1
Safety guidelines on
working with compres-
sed air and paint
sprays
Note: Please read UVV-VBG 16
Compressors and pipes reach high
temperatures during operation. If
touched, they will burn.
The gases or vapours taken in by
the compressor must be kept free
of impurities, since these could
cause fires or explosions in the
compressor.
When removing the hose coupling,
the coupling piece should be held
firmly in order to avoid any injury
from the hose recoiling.
When working with the spray gun,
protective goggles should be worn.
Injuries can easily be caused by
foreign bodies and parts blown to
the side.
Never point the spray gun at people
or use it to clean clothes when wea-
ring them.
Seite 7
300/50 W 300/100 W
230 V ~ 50 Hz
1,5/2,0 1,5/2,0
1700 1700
10 10
50 90
160 160
300 300
40.251.00 40.253.00
90013 90013
Please note the follo-
wing safety guidelines
when spraying paint.
Note: Please read UVV-VBG 23
G Do not use paint or solvents with
a flashpoint lower than 21° C.
G Do not heat up paint and sol-
vents.
G If liquids are used that are harm-
ful to health, filters (face masks)
should be used for protection.
Instructions on protective mea-
sures issued by the manufactu-
rers of such substances should
also be noted.
G Smoking is not permitted during
spraying or in the working area.
Paint vapours are also easily
flammable.
G Keep away from fires, naked fla-
mes and machines causing
sparks.
G Do not keep or consume food
and drink in the working area.
Paint vapours are harmful.
G The working area must be larger
than 30 m3, and there should be
sufficient changes of air during
spraying and drying. Do not
spray against the wind. Basi-
cally, when spraying flammable
GB
400/50 D 400/100 D
400 V 3 ~ 400 V 3 ~
2,0/2,7 2,0/2,7
1700 1700
10 10
50 90
240 240
400 400
40.311.00 40.315.00
90013 90013
7