Publicité
Les langues disponibles
Les langues disponibles
A
Fig. 6.10
C
Fig. 6.11
C
Fig. 6.12
24
A
A
D
B
A
D
B
A
FASTENING THE COOKTOP
Each cooker top is provided with an
installation kit including brackets and
screws for fastening the top to fixture
panels from 20-30 to 40 mm thick, figs.
6.11 (2 electrical plates hob) e 6.12 (vit-
A
roceramic hob).
Cut the unit.
Stretch gasket "D" over the edge of
the hole made, being careful to over-
lay the junction edges
Turn the cooktop over and put tabs
"A" (fig. 6.10) into the mountings, only
tighten screws "B" a few turns.
Make sure that the tabs are mounted
correctly as shown in the figures 6.11
and 6.12. Turn the tabs so that the
cooktop can be put into the hole.
Put the cooktop into the hole cut into
the unit and position it correctly.
Put tabs "A"; into place, tooth "C" of
the tabs should go into the hole.
Tighten screws "B" until the cooktop is
completely secured.
Using a sharp tool cut off the part of
gasket "D" which protrudes from the
cooktop.
Publicité
