EUROM Safe-t-Fanheater 2000 Manuel D'utilisation page 18

Remote control panel and remote control:
1. ON/OFF button
2. Timer button
3. High/low output button
4. Temperature & duration higher
5. Temperature & duration lower
6. Symbol high/low output active
7. Output set at 1000W
8. Output set at 2000W
Set-up and Operation

Set the main switch (back) to I (on). You can now operate the heater with buttons
1 to 5 on the control panel or the remote control.

Press once on the on/off button (1); the heater will start to work and the LCD
screen will light up.

By pressing once or twice on the high/low output button, you can select the low
(1000W) or high (2000W) setting, respectively. Symbol 7 or 8 indicates this. If the
room temperature is under the set temperature, the heater will heat at 1000 or
2000W. As the heater is heating, symbol 6 will blink: half for 1000W, full for
2000W.

Set the desired temperature by pressing buttons 4 (higher) or 5 (lower). Symbol
12 will blink for a few seconds to indicate the set temperature; symbol 9 and 10
will blink too. After a few seconds, the 9 will go out and the display (12) will once
again show the ambient temperature. The temperature can be set to between 15
and 45°C. If the set temperature is lower than the ambient temperature, the
heater will stop heating and just ventilate. When the ambient temperature drops
below the set temperature, the heater will once again blow out hot air.

In order to set a specific time with the timer, press the timer buttons (2) when the
heater is on. Symbol 15 (usually set to 00) will begin to
blink and you can now use the + and - buttons to set
and/or adjust the functional period (from 0 to 24
hours). Every time you press the button the set period
is increased or decreased by one hour. By pressing
the timber button again, you confirm the setting and it
will stop blinking. The heater will now function for the
set period and then automatically switch off.

Pressing on the on/off button will switch the heater off.
Press the main switch again (O) and remove the plug
from the socket.
Safety features
The heater is fitted with a tipping safeguard which automatically shuts off the
appliance if it inadvertently falls over. When the heater is returned to its upright
position, it will resume functioning as normal but, before reusing, switch if off, unplug
and check for damage. Do not use the heater if it is damaged or malfunctioning, but
have it inspected/repaired!
In case of internal overheating, the overheating safeguard will switch the heater off.
This may occur if the heater cannot give off enough heat or if it cannot draw in
9. Symbol 'temperature is set'
10. Symbol 'temperature' (TEMP)
11. Symbol '°C'
12. Display of set and room
13. Symbol 'timer active' (TIMER)
14. Symbol 'timer on display' (H)
15. Set functional duration
18
(SET)
temperature