EUROM Safe-t-Fanheater 2000 Manuel D'utilisation page 17

Set-up and Operation
Safe-t-Fanheater 2000:

Turn the thermostat dial to maximum (clockwise as far as possible).

Switch the heater on by turning the control dial to one of the following three
positions:
Fan only (thermostat always to maximum)
I
Heating at half power (1000W)
II
Heating at full power (2000W)
The light at the front will turn on.
It is most economical to heat the space at full power, then to switch to half power
to maintain the temperature.

Both at half and full power, the fan rotates at the same speed; the difference
between the two lies in the number of heating elements in use.

Once the desired temperature is reached, turn the thermostat dial back slowly
until you hear a click. The temperature is now set. The heater will automatically
switch on and off to maintain the set temperature. When the heater switches off,
the pilot light turns off as well. To set a higher or lower temperature, turn the
thermostat dial either clockwise or anticlockwise.
 To switch the heater off set the control dial to '0' (off). The pilot light will turn off.
The pilot light, in other words, indicates that the heater is switched on, not that
the heater is connected to the mains!

Unplug.
Safe-t-Fanheater 2000 LCD:
17