EUROM Safe-t-Fanheater 2000 Manuel D'utilisation page 13

cannot fall into water and prevent water from getting
into the heater itself. If, at any time, the heater does
fall into water, unplug it immediately! Do not use a
heater that has a damp interior but have it repaired.
Never immerse the heater, cord or plug in water and
never touch it with wet hands. Do not place the
appliance in an open window to avoid rain or on wet
surfaces and avoid that no moisture spillage.
5. The supply voltage and utility frequency, specified on
the machine, need to match those of the socket that
is used. The electrical installation needs to be
protected by a residual current device (max. 30
mAmp).
6. Fully extend the cord before plugging in the heater.
Make sure it does not come into contact with any part
of the heater and prevent it from heating up any other
way. Do not run the cord underneath carpeting; do
not cover it with mats, carpet strips, or similar and
make sure it is not placed in any passageways. Make
sure the cord cannot be stepped on and that no
furniture is placed on top of it. Do not lead the cord
around sharp corners and do not roll it up too tightly
after use!
7. If possible, do not use an extension cord, as this
poses the risk of overheating and fire. If the use of an
extension cord is unavoidable, then make sure it is
an undamaged, approved extension cord with a
minimum diameter of 2 x 2.5 mm² and a minimum
permissible power of 2000 Watt/10Amp. To prevent
overheating, always fully extend the cord!
8. To prevent the circuit being overloaded and fuses
being blown, make sure no other appliances are
connected to the same socket or wired to the same
electrical circuit as the heater.
9. Do not use the heater outdoors and do not use it in
spaces smaller than 15 m³.
10. A heater contains hot and/or glowing and sparking
components. Do not, therefore, use it in areas where
13