EUROM Safe-t-Fanheater 2000 Manuel D'utilisation page 16

26. Only use this heater for its intended purpose and as
described in this instruction manual.
Not abiding by instructions 24, 25 & 26 may lead to
damage, fire and/or personal injuries. A failure to adhere
to these rules also immediately nullifies the guarantee
and vendor, importer and/or manufacturer do not take
responsibility for any of the consequences!
Description
1 – Control dial
2 – Thermostat dial
3 – Pilot light
4 – Fan grille
Location and Connection

Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact
your vendor for inspection or replacement.

Choose a suitable location for the heater which is at least one metre away from
any obstructions, walls or inflammable materials (see also safety instructions).

Make sure a functioning heater is always placed on a solid, flat and horizontal
surface.

Safe-t-Heatfan 2000 LCD: Install 2 AAA batteries (not included) in the remote
control
Safe-t-Heatfan 2000 LCD: set the main switch to O (off)
Fully extend the power cord and plug into a suitable 220-240V socket. To
prevent the circuit overloading, check that no other appliances are connected to
the same group.
A – LCD screen
B – Control panel
C – Receiving point – remote control
D – Remote control
E – Fan grille
F – Main switch (back)
16