Adapting Microwave Blower For Outside Back Exhaust - Haier HM1630 Guide De L'utilisateur

English
B5. ADAPTING MICROWAVE BLOWER FOR OUTSIDE BACK
EXHAUST
1. Remove and save screw that holds
blower motor to microwave.
2. Carefully pull out the blower unit. The
wires will extend far enough to
allow you to adjust the blower unit.
3. Roll the blower unit 90°
Before Rotation
Back of
Microwave
5. Gently remove the wires from the
grooves. Reroute the wires through
grooves on other side of the blower unit.
Before Rerouting
Wires Routed Through Right Side
7. Place the blower unit back into the
opening.
CAUTION: Do not pull or stretch the
blower unit wiring. Make sure the wires
are not pinched, and that they are
properly secured.
NOTE: The blower unit exhaust
openings should match exhaust
openings on rear of microwave oven.
8. Secure the blower unit to the
microwave with the original screw.
9. Replace the blower plate in the
same position as before with the
screw. Make sure the screw is tight.
19
After Rotation
Back of
Microwave
After Rerouting
Wires Routed Through Left Side
Blower Motor
Before: Fan Blade
Openings Facing
Forward
End A
4. Rotate blower unit counterclockwise 180°.
Before Rotation
Back of
Microwave
6. Roll the blower unit 90° so that fan blade
openings are facing out the back of the
microwave.
Before Rolling
Back of
Microwave
AFTER: Fan Blade
Openings Facing Back
End B
Back of
Microwave
Blower Motor
Screw
End B
After Rotation
Back of
Microwave
After Rolling
Back of
Microwave
End A
Blower Plate
Back of
Microwave
Blower Motor
Screw