Recirculating; Attach Mounting Plate To Wall; Check Blower Plate - Haier HM1630 Guide De L'utilisateur

C. RECIRCULATING
INSTALLATION OVERVIEW
C1. Attach Mounting Plate to Wall
C2. Prepare Top Cabinet
C3. Check Blower Plate
C4. Mount the Microwave Oven
C5. Install or change Charcoal Filter
IMPORTANT NOTES:
Make sure the screws for the blower motor and blower plate are securely
tightened when they are reinstalled. This will help to prevent excessive vibration
Make sure the motor wiring has been properly routed and secured, and that
the wires are not pinched.
C1. ATTACH THE MOUNTING PLATE TO THE WALL
Attach the plate to the wall using toggle
bolts. At least one wood screw must be
used to attach the plate to a wall stud.
1. Remove the toggle wings from the bolts.
2. Insert the bolts into the mounting plate
through the holes designated to go into
drywall and reattach the toggle wings to
3⁄4" (19 mm) onto each bolt.
TO USE TOGGLE BOLTS:
3. Place the mounting plate against the
wall and insert the toggle wings into the
holes in the wall to mount the plate.
NOTE: Before tightening toggle bolts and wood screw,
make sure the tabs on the mounting plate touch the
bottom of the cabinet when pushed flush against the wall
and that the plate is properly centered under the cabinet.
CAUTION: Be careful to avoid pinching fingers
between the back of the mounting plate and thewall.
4. Tighten all bolts. Pull the plate away
from the wall to help tighten the bolts.
(NON-VENTED DUCTLESS)
Toggle Wings
Mounting
Plate
Spacing for Toggles
More Than Wall
Thickness
Toggle
Bolt
Wall
Bolt End
English
22