Adjust The Exhaust Adaptor; Connecting Ductwork - Haier HM1630 Guide De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

A5. MOUNT THE MICROWAVE OVEN
1.
Lift microwave, tilt it forward, and hook slots
at back bottom edge onto four lower tabs of
mounting plate.
2.
Rotate front of oven up against cabinet
bottom.
3.
Insert a self-aligning screw through top
center cabinet hole. Temporarily secure
the oven by turning the screw at least two
full turns after the threads have engaged.
(It will be completely tightened later.) Be
sure to keep power cord tight. Be careful
not to pinch the cord, especially when
mounting flush to bottom of cabinet.
4.
Attach the microwave oven to the top cabinet.
5.
Insert 2 self-aligning screws through outer
top cabinet holes. Turn two full turns on
each screw.
6.
Tighten center screw completely.
5
7. Tighten the outer two screws to the top of the microwave oven. (While tightening
screws, hold the microwave oven in place against the wall and the top cabinet.)
8. Install grease filters. See the Owner's Manual packed with the microwave.
A6. ADJUST THE EXHAUST ADAPTOR
Open the top cabinet and adjust the exhaust
adaptor to connect to the house duct.
A7. CONNECTING DUCTWORK
1.
Extend the house duct down to connect
to the exhaust adaptor.
2.
Seal exhaust duct joints using duct tape.
6
NOTE: When mounting the
microwave oven, thread power
cord through hole in bottom
of top cabinet. Keep it tight
throughout Steps 1–3. Do
not pinch cord or lift oven by
pulling cord.
2
Cabinet Front
Cabinet Bottom Shelf
Microwave Oven Top
Damper
Blower Plate
English
English
1
Filler Block
Equivalent
to Depth
of Cabinet
Recess
Self-Aligning Screw
Back of
Microwave
For Front-to-Back or
Side-to-Side Adjustment,
Slide the Exhaust Adaptor
as Needed
House Duct
16

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Mw-7777-01

Table des Matières