Mount The Microwave Oven - Haier HM1630 Guide De L'utilisateur

English
C2. USE TOP CABINET TEMPLATE FOR PREPARATION OF
TOP CABINET
You need to drill holes for the top support
screws, a hole large enough for the power
cord to fit through.
Read the instructions on the TOP
CABINET TEMPLATE.
Tape it underneath the top cabinet.
Drill the holes, following the instructions
on the TOP CABINET TEMPLATE.
Wear safety goggles when drilling holes in the cabinet bottom.
C3. CHECK BLOWER PLATE
Place the microwave in its upright
position, with the top of the unit facing up.
Check to see that the blower plate is
correctly installed on the unit.
C4. MOUNT THE MICROWAVE OVEN
FOR EASIER INSTALLATION
AND PERSONAL SAFETY, WE
RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, use the
nylon grommet around the power cord
hole to prevent cutting of the cord.
1. Lift microwave, tilt it forward, and hook slots
at back bottom edge onto four lower tabs of
mounting plate.
2. Rotate front of oven up against cabinet
bottom.
23
CAUTION:
NOTE: We recommend using filler
blocks if the cabinet front hangs below
the cabinet bottom shelf.
IMPORTANT: If filler blocks are not
used, case damage may occur from
overtightening screws.
NOTE: When mounting the
microwave oven, thread power
cord through hole in bottom
of top cabinet. Keep it tight
throughout Steps 1–3. Do
not pinch cord or lift oven by
pulling cord.
2
Blower Plate
1